Heavy Battery Product Features and Maintenance
1, simple maintenance: rechargeable heavy-duty internal battery generated by the basic absorption of reduced to the electrolyte, the basic no electrolyte reduction.
2, holding liquid high electrolyte is absorbed in a special partition, keep the flow state, so even if the fall can also be used. (Down more than 90 degrees can not be used)
3, superior safety performance: due to extreme overcharge operation errors caused by excessive gas can be released to prevent the rupture of heavy batteries.
4, self-discharge is very small: with special lead calcium alloy production grid, Heavy Duty Battery Cell the self-discharge control in the smallest.
5, long life (design life of 3 to 6 years) good economy: heavy-duty battery grille with good corrosion resistance of special lead calcium alloy, while the use of special partitions to keep the electrolyte, and then with a strong compression of the positive plate activity Material, to prevent falling off, so it is a long life, Heavy Duty Battery Cell the economy of heavy batteries.
6, the internal resistance of small: due to small internal resistance, Heavy Duty Battery Cell high current discharge characteristics.
7, after the deep discharge of excellent recovery capacity: In case of long-term discharge, as long as the full charge, the basic capacity does not appear to be reduced, and soon can be restored
Note: When the heavy battery discharge is complete,
We use the heavy battery when the battery is sometimes finished after the time did not charge, resulting in heavy battery loss phenomenon, Heavy Duty Battery Cell the next time you re-use can not be properly charged when the power, so we recommend to you the heavy battery is the discharge Should be charged immediately after.
A heavy-duty battery with a load discharge to a low power state must be recharged within 72 hours after discharge to avoid damage to the heavy battery. When the UPS is not in use, it should disconnect the heavy battery, or in a few days to a week will lead to the connection of heavy batteries over discharge and damage, Heavy Duty Battery Cell if the heavy battery after a long time without recharging, will lead to Plate oxidation, that is, a large number of crystal or solidified lead sulfate to stay in the heavy metal plate metal plate, the commonly used method of charging will be difficult or can not re-lead sulfate re-decomposition, which will lead to premature damage to heavy batteries The
So after the use of heavy batteries, as far as possible the first time to charge, iHeavy Duty Battery Cell t can also extend the life of heavy batteries